![]() FASSTest receivers have no other way of sending external telemetry other than the S.Bus2 port. When you are setting the 7003SB to use the external telemetry cable/adapter you are essentially turing that port into an S.Bus2 port. With the SBS-01V there's no need for the CA-RVIN-700 cable, when the EXT-VOL CABLE is used with the R7003SB the CA-RVIN-700 (or an equivalent ) is needed.įact is you cannot directly plug the cable into the R7003SB. The only thing they have in common is that they both can measure voltage - the SBS-01V range is 0-100V while the EXT-VOL CABLE + CA-RVIN-700 combo is good for 0-70V. The SBS-01V works ONLY with an S.BUS2 port while the EXT-VOL CABLE works only with Port2 of the R7003SB. ![]() The "EXT-VOL CABLE" is not the same as the SBS-01V Voltage Sensor. ![]() I agree that we have a disagreement but you have to check your facts, especially claiming to represent Futaba in some way: You plug it into the "adapter"/sensor and that gets plugged into the S.Bus2 port. You cannot just plug the cable directly into an external voltage port like you can on the 7008. The adapter that comes with the RX and the separate sensor are essentially the same thing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |